Spektrum DX8 Manual de Instruções descarregar pdf (Página 35)





The Monitor screen displays the servo positions for each channel graphically and

numerically. This is useful to verify programming functions, trim settings, mix

directions, etc. The numeric value is directly relative to the travel adjust and mix

values (e.g., 100% travel adjust equals 100% value in the Monitor).



With the transmitter on and the main or telemetry screen displayed, press the

roller. The Function list will display.

Rotate the roller to highlight Monitor then press to access.



 Solution

•Thesystemwillnot

connect

•Yourtransmitterandreceiveraretooclose

together. They should be 8 to 12 feet apart.

•Youarearoundmetalobjects.

•Modelselectedisnotthemodelboundto.

•Yourtransmitterwasaccidentallyputinto

bind mode and is not bound to your receiver

anymore.

•Movetransmitter8to12feetfromreceiver.

•Movetoanareawithlessmetal.

•Checkmodelselectedandensureyouarebound

to that model.

•Rebindyourtransmitterandreceiver.

•Thereceivergoesinto

failsafe mode a short

distance away from the

transmitter

•Checkthereceiverantennatobesureitisnot

cut or damaged.

•Mainandremotereceiverstooclosetogether

•ReplaceorcontactHorizonProductSupport

•Mountmainandremotereceiversatleast2

inches apart and perpendicular to each other.

•Receiverquitsresponding

during operation

•Inadequatebatteryvoltage

•Looseordamagedwiresorconnectosbetween

battery and receiver

•Chargebatteries.Spektrumreceiversrequire

at least 3.5V to operate. An inadequate power

supply can allow voltage to momentarily drop

below 3.5V and cause the receiver to brown out

and reconnect.

•Checkthewiresandconnectionbetweenbattery

and receiver. Repair or replace wires and/or

connectors

•Receiverlosesitsbind

•Transmitterstandortraycouldbedepressing

the bind button

•Bindbuttonpressedbeforetransmitterturned

•Ifstandisdepressingbindbutton,removefrom

stand and rebind.

•Rebindyoursystemfollowingbinding

instructions

•Receiverblinkingat

landing

•Abrownouthasoccurred

•Systemturnedonandconnectedthenreceiver

turned off without turning off transmitter

•Checkbatteryvoltage

•Turnofftransmitterwhenreceiveristurnedoff

•RPMwon’tread/display

•Sensortooclosetobackplate;pickinguptipof

crank pin only

•Movesensorsawayfrombackplate

•Temperaturesensorseems

to read low

•Temperaturesensormountedonfrontof

cylinder head being hit by direct prop blast

•Mountsensorbehindcylinderhead.When

installing sensors note engine temperature

with engine properly tuned. Use this as

reference value. If temperature goes above this

signiﬁcantly, the engine is running too low



1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41 42

Comentários a estes Manuais

Sem comentários

Spektrum DX8 Manual de Instruções Página 35

Comentários a estes Manuais

Manuais e produtos relacionados com Controlos remotos Spektrum DX8